|
- COAT THE INSIDE OF THE MOLD WITH MOTOR OIL
- DO NOT USE UNREFINED OIL OR EDIBLE OIL
- FIX CONICAL FORMER TO BASE-BOARD AND COAT WITH MOTOR OIL (Pict. 1)
- JOIN THE TWO HALVES OF THE MOLD USING SCREWS
- PLACE OVER CONICAL FORMER AND HOLD TIGHT ONTO BASE-BOARD USING STRONG ROPE (Pict. 1)
- MIX CONCRETE (0-1 mm GRANULATION) IN PROPORTION 1:3
- ROTATE THE MOLD TO ACHIEVE EVEN SETTING WHILE POURING IN THE CONCRETE
- TOWARDS THE END OF SETTING PERIOD, INSERT TWO 6mm RODS AS SHOWN
- ALLOW THE WASE TO DRY FRO 24 HOURS
- LATER, DRILL A HOLE FOR DRAINAGE
- THE VASES ART. 402 IS COMPLETED BY JOINING THE TWO PARTS USING CONSTRUCTION GLUE
|
|
