|
- ON BOARD MOUNT UNDER MOLD WHICH IS SUPPORTED WITH WOODEN PILLARS, AND OVER THEM MOUNT UPPER MOLD, BOTH MOLD COAT WITH MOTOR OIL (Pict. 1)
- FASTEN MOLDS WITH SCREWS AND AT THE TOP MOUNT ARMATURE WITH DOUBLE DOWNRIGHT BAR ø 6mm (Pict. 2)
- BEFORE POURING THE CONCRETE IS NECESSARILY TO ADDITIONALY FASTEN MOLDS TO PREVEN DEFORMING UNDER THE OPPRESSION OF CONCRETE (Pict. 3).ALSO THE SAME ROLE HAVE A PILLARS IN INTERNAL MOLD. IN RECUPERATED MOLDS WE POUR CONCRETE SOFTLY AND ROLL THEM OVER TUBES, TOWARDS BETTER SEGREGATION OF CONCRETE
- AFTER 24 HOUR MOLD CAREFULLY SEPARATE INTO ITS ELEMENTS AND WE ATTAIN FINISHED FLOWER-STAND OUT WHICH OVERLAP TWO ARMATURE BARS ø 6mm (Pict. 4)
- ON BOARD MOUNT TUBE AND OVER HIM BASE MOLDE. THROUGH THE MIDDLE MOUNT PLASTIC TUBE ø 50mm WRAPED WITH NYLON, TO BE ABLE TAKE OUT AFTER THE DRYING, POUR CONCRETE WITH ROTATING, METHOD IS UNCHANGED LIKE WITH FLOWER-STAND (Pict. 5)
- FINISHED FLOWER-STAND TURN OVER BACKWARDS AND ON PULL OVER THE BASE. ALL HOSE WITH CEMENT AND ADAPT JOINTS WITH CONSTRUCITVE GLUE (Pict. 6)
- AFTER 24 HOURS OF DRYING FLOWER-STAND WITH BASE MOUNT IN VERTICAL POSITION (sl. 7)
- ON TWO ENDS OF FLOWER-STAND DRILL HOLESE ø 10mm FOR DRAINING OF WATER, PUT THE LAND AND LAY OUT PLANTS
- WE ARE NOT ENGAGED FOR LAY AND FAILURE TO COMPLY WITH INSTRUCTIONS
- NOTICE: IN THE EVENT OF POURING WITHOUT PEDESTAL ARMATURE IS NOT NECESSARILY
|
|
